> 41-50 of 58
12mm Nut-driver with spring steel shaft and knurled aluminium handle.
Composite tool to aid checking of main diff pulley slippage. Suitable for both the Serpent 710 and 835.
Lightweight aluminium Centax 3 clutch bell gripper. Comes with steel fixing pin.
Composite tool for seperating the Spur gear from the 2nd gear aluminium carrier. Only works with the LC Gearbox.
Handy composite tool for adjusting the Centax clutch nut and for the mounting the fuel line nipples.
Set of 2 plastic Centax 3 pinion gear tools to help fasten the pinon gears to the bell housing. Fits all gears (16-18T, 20-23T).
New tool for use with the Centax-II bell housing. Made from spring steel and comes with pin to aid the application of the pinion gears.
Tool for mounting the rear upper wishbone pivot ball. Comes supplied with screw to aid mounting. Can be used for all Serpent cars.
Special tool to mount pinions on Centax clutch housing. Fits 15-16-17-18-19-20T pinions. Made of durable composite nylon.
The ultimate set up tool for tuning the Veteq. Because the Veteq chassis is in two pieces and the chassis surface is not completely flat, we have created these 3 posts which enable you to set your car level to measure droop more accurately.Made from aluminium these posts fit perfectly into the 3 mounting holes in the Veteq´s 2 chassis plates. The posts come with rubber o-rings which make placement into the chassis easier.Suitable for the Veteq and Vector NT.